Nortel RLC, Installation And Administration Manual

Page: 354 / 466

328 RLC Installation and Administration Guide
Planning forms Standard 4.0
Completing the RLC forms
To complete the forms:
1 Assign users on the remote units to remote ports on the RLC.
Note:
To do this effectively, obtain information from the configuration
information forms for all remote units connected to this RLC.
Record the RLC port assignments in the “Port configuration” section on one
of the following RLC forms (according to the type of RLC installed):
„
Connection Information—16 ports
„
Connection Information—32 ports
Users who are using an MCA to transmit data must be assigned to a PBX
data port. Users who are using ATAs can be assigned to PBX voice or data
ports. Configure ATA users as voice ports only if there are not enough free
data ports. Refer to “Remote port configuration” on page 112 for more
information.
Note:
The Connection Information forms identify the maximum number of
ports that can be associated with MCAs and ATAs that are used to transmit
data.
2 If you want to route calls over the PSTN, designate RLC ports to be used
as network ports. At the same time, identify the telephone number that will
be used to establish the connection with the remote unit.
Note:
You must assign Network ports to PBX data ports.
Record the network port assignments and remote unit PSTN numbers on
the Connection Information form for your RLC type.
3 Record the IP address for each remote unit on the Connection Information
form for your RLC type.
ATTENTION!
Before you can assign RLC ports to remote users, you must
determine the total remote user requirements for the RLC.