Nortel RLC, Installation And Administration Manual

Page: 252 / 466

226 RLC Installation and Administration Guide
Configuring the RLC Standard 4.0
DSP Configuration field descriptions
Field Description
Module Number Select the number of the module that the DSP devices that
you want to choose compression algorithms for are located
on.
Note: Module 0 represents the main board (RLC or
Remote Gateway 9150 unit). Modules 1 and higher
represent plug-in modules.
The default is 0.
No of Devices This read-only window displays the number of DSP
devices available on the DSP module you selected in the
Module Number field. Refer to “DSP configuration” on
page 224 for an explanation of DSP
devices versus DSP
modules and DSP channels.
This read-only value is 2.
Device Number 1 or 2
DSP Load
Note: This description
applies to both appearances
of this field.
Select the DSP Load providing the collection of
compression algorithms that you would like loaded on the
selected DSP according to the compression algorithms
displayed in the Compression Algorithms window.
Valid options are G.729A, 911X, G.723_CONF, and
AUTO.
The default is AUTO.
Notes:
1. G.723_CONF allows you to record telephone calls
using the CallParrot Business Call Recording feature.
For more information regarding CallParrot, contact
your TelStrat representative.
2. Selecting AUTO instructs the RLC to choose a default
DSP load. This default load is G.729A, depending on
DSP channel availability.