Nortel RLC, Installation And Administration Manual

Page: 246 / 466

220 RLC Installation and Administration Guide
Configuring the RLC Standard 4.0
Configuring an Online/Offline Table
To configure the Online/Offline Table:
1 Access the Remote Connection Configuration property sheet.
2 Ensure that the Unit ID drop down box shows the Unit ID for the remote unit
you want to configure an Online/Offline Table for. If it does not, choose the
proper Unit ID from the drop down box, such as
1 — 20 .
3 Ensure that the Unit Type drop down box properly reflects the remote unit
you want to configure an Online/Offline Table for. If it does not, choose the
proper Unit Type from the drop down box, such as
9150 or 911X .
4 Click on the Online/Offline button.
Result: The Online/Offline Table dialog box displays. (Refer to “Online/
Offline Table” on page 219.)
5 From the Day drop down box, select the day of the week that you want the
remote unit to have access to the network (PSTN or IP).
6 In the enabled State drop down box, choose Online or Offline , according
to the command you want the system to initiate for this remote site.
Result: Configuration Manager enables the associated Time list box and
the State and Time list boxes immediately below. The chosen state ( Online
or Offline ) displays in the list box.
Note: If you choose Undefined , the subsequent list boxes remain disabled.
Configuration Manager takes your choice of Undefined to be an indication
that you do not want to configure more commands in this Online/Offline
Table.
7 In the associated Time list box, choose the time (24-hour time format) that
you would like Configuration Manager to initiate the state chosen in step 5.