Nortel RLC, Installation And Administration Manual

Page: 187 / 466

RLC Installation and Administration Guide 161
June 2005 Using Configuration Manager
Performing a system restart or shutdown
Configuration Manager allows you to perform a controlled system restart or
shutdown.
When to perform a restart or shutdown
Each time that you make a configuration change, perform a Save to Flash. You
must also restart the unit if Configuration Manager prompts you to do so.
Note: When you save configuration changes to Flash, the system suspends new
call processing for approximately 30 seconds. Some configuration changes do
not take effect until the unit has been re-started.
You can perform a system shutdown when you need to power the system down.
Performing a system restart
To perform a system restart:
1 From the Menu Bar, choose Connect
→
System Reset
→
Restart.
Result: The System Restart dialog box displays, similar to the following:
2 Click on the Yes button.
Result: The following status dialog box displays:
The following message also displays in the status bar at the bottom of the
screen:
Restarting the System