Nortel RLC, Installation And Administration Manual

Page: 140 / 466

114 RLC Installation and Administration Guide
Configuring the host PBX for the RLC Standard 4.0
PBX
Configure the host PBX as follows:
1 Program the data TN for a digital set.
a. If you have a telephone programmed against the voice TN, then the
data TN telephone type must be the same as the voice TN telephone
type. For example, if the telephone on voice TN 6 15 is a 2616 then the
fax data TN 6 31 must be programmed as 2616.
b. Set DTAO = MCA
c. Set the DN of the fax machine or ATA on Key 0 of the data TN.
2 After programming the data TN, go back in again to change the CLS. Do one
of the following:
„
If the system software includes package 186, program an ATA by
adding CLS=FLXA VCE CPTD.
„
If you do not have package 186 then, add CLS =FLXA VCE.
3 Enable the TN in LD 32.
RLC
Configure the corresponding ports on the RLC as follows:
1 Access Configuration Manager
→
RLC
→
RLC Port Configuration.
2 On the RLC port that matches the ATA port, configure the compression,
priority and usage. This port must also be configured as a remote port, not a
network port.
3 Click on the OK button on the RLC Port Configuration window, send to unit,
save configuration to Flash and reboot the unit.
Notes:
a. When you save configuration changes to Flash, the system suspends
new call processing for approximately 30 seconds.
b. If you intend to use a fax on the ATA device, or you are programming
the 9150 fax port, Nortel recommends using the G.729A/Fax
compression algorithm.