Nortel RLC, Installation And Administration Manual

Page: 118 / 466

92 RLC Installation and Administration Guide
Installing the RLC Standard 4.0
Using the Configuration Wizard to perform
initial configuration
The Configuration Wizard option in Configuration Manager allows you to
configure the minimum information needed for establishing communications
between the RLC at the host site and the following remote-site products:
„
Remote Gateway 9110
„
Remote Gateway 9115
„
Remote Gateway 9150
„
Digital Telephone Internal IP Adapter
„
Digital Telephone External IP Adapter
The Configuration Wizard provides only a subset of the full configuration
settings available in Configuration Manager. However, by using the
Configuration Wizard, the RLC can be up and running within 10 minutes.
You can use the Configuration Wizard in offline mode or while connected and
logged on to the RLC (online mode).
What you can configure with the Configuration Wizard
The Configuration Wizard allows you to configure the following elements:
„
the RLC’s IP address, subnet mask, and default gateway
This information must be valid for your IP network.
Note: If you do not plan to use the IP network to route calls, you must still
enter this information for administration purposes. If you do not have an IP
network in place, the procedure on page 97 provides sample information.
„
for Voice over IP capability:
— the IP addresses for each remote unit connected to the RLC
„
for PSTN capability:
— the RLC port used for connection to the remote unit
— the telephone number of the remote unit