Nortel Remote Office 9150, Installation And Administration Manual

Page: 214 / 570

186 Remote Gateway 9150 Installation and Administration Guide
Configuring the Remote Gateway 9150 unit Standard 4.0
International tones support
International Tones support allows users to integrate Remote Gateway 9100
Series seamlessly into their existing telecommunications networks in countries
that use tones different from North American tones, which are the defaults.
Determine existing tone configurations for each field in the International Tone
Support dialog box by accessing LD 56 through the switch administration
terminal. The exact procedure for accessing LD 56 is available in documentation
for your specific PBX.
The Tone Code field on the International Tones Support dialog box specifies the
frequency and levels for the NT8D17 TDS card.
When configuring International Tones, consider the following:
„
International Tone configuration uses NT8D17 card Tone Codes. These
codes are valid for all countries and Meridian 1 PBX 11 or IPE Controller
cards.
„
To configure the four international tones, you need to obtain the following
FTC values for DIAL, RGBK, BUSY and OVFL from LD 56 of your PBX:
>ld 56
REQ pr t
TYPE F TC
Look for the DIAL,RGBK, BUSY and OVFL values.
…
DIAL
XTON 1 29
Enter the XTON value as the “Tone Code” value for this
XCAD 0 00
tone. XCAD is used below to determine the Repeat, No.
RGBK
of Cycles and Cadence Time.
XTON 1 32
XCAD 3 2
BUSY
XTON 1 30
XCAD 3 0
OVFL
XTON 1 30
XCAD 0