Nortel Remote Office 9150, Installation And Administration Manual, Page: 208 / 570

180 Remote Gateway 9150 Installation and Administration Guide
Configuring the Remote Gateway 9150 unit Standard 4.0
Emergency Feature Click on the Emergency Feature button to configure
emergency activation codes.
Result: The Emergency Activation Code dialog box
displays.
„
Emergency Code
Enter the number that the user must dial to tell the PBX
to send to the CO the emergency service telephone
number in the Dialed Number field immediately to the
right.
The first default is 911. Subsequent defaults are NC
(Not Configured).
„
Dialed Number
Enter the DN of the emergency service that you want
the PBX to send to the CO when the user dials the
Emergency Code in the field immediately to the left.
The first default is 911. Subsequent defaults are NC
(Not Configured).
Note: Enter only the Emergency Activation Code (for
example, 911 in North America). Do not include the trunk
access code because the Emergency Activation code dials
out directly on the PSTN.
If you are using only the IP network to route calls, leave
this field blank.
Click on the
OK button.
Refer to “Emergency service programmability” on page
176 for further details on this feature.
Field Description