Nortel Passport 7400, Hardware Installation, Maintenance, And Troubleshooting, Page: 430 / 438

430 Chapter 37 Hardware procedures
241-7401-240 5.2S1
Procedure job aid
Table 13
Equipment checklist for unpacking a cabinet
Equipment
Cabinet with pre-installed:
• doors (2) and keys (2)
• switch shelving (1 or 2)
• function processors (1 to 15 for each switch)
• blank processor cards (14 for each switch less the number
of processors)
• cooling units and cables
• cable management unit(s)
• door alarm cables
Power supplies (up to 3 for each switch) and blank power
supplies if switch contains fewer than three power supplies
Control processors (1 or 2 for each switch)
Blank control processor card (if the switch contains only 1
control processor)
Function processor cables, as required
Termination panels, as required for function processors
Grounding cable for termination panels
Grounding strips for termination panels (1 for each panel)
Power cords (1 for each power supply)
Power cord selector guide
Antistatic wrist strap
Optional: anchoring kit
Optional: eyebolts (4)