Nortel Passport 15000, Hardware Installation And Maintenance, Page: 776 / 874

776 Chapter 17 Hardware procedures
241-1501-240 5.2S2
Removing the packaging from a Passport in a frame
Remove the packaging from a Passport in a frame before moving the switch
off the pallet.
Prerequisites
• The packaging for a Passport 15000 or 20000 in a NEBS 2000 frame is
typically a wooden crate surrounding it on a pallet.
Procedure steps
1 Use a pair of pliers to straighten and remove the fastening tabs around the
lid. Refer to the figure “Unpacking a horizontal Passport 15000 or 20000
in a frame” (page 777).
2 Lift the lid away from the crate.
3 Straighten and remove the fastening tabs along the base of the crate.
4 At each end of the crate, one corner is permanently joined to a side
(without tabs). The joined corners are diagonally opposite each other.
Straighten and remove the fastening tabs along the corner at each end of
the crate, working from bottom to top.
After the tabs are unfastened, be prepared to catch the L-shaped panels
if they fall away from the crate. Packing foam may fall with the panels.
5 Move the lid and panels away from the pallet so that there is enough room
to safely stand the frame on end off the pallet.
6 Remove the foam packaging from around the frame.
7 Store all panels, padding materials, and tabs aside for re-use later.