Nortel Passport 15000, Hardware Installation And Maintenance, Page: 409 / 874

Chapter 17 Hardware procedures 409
Passport 15000, 20000 Hardware Installation, Maintenance, and Upgrade 5.2S2
stress by adjusting the angel of the cable’s bent tab terminal on the door,
for example, to point at an angle.
10 Fasten the eye-looped end of the ground cable shown in the figure to the
mounting ear of the top frame bracket. See the figure “The cable
NTRU0103 to ground the door to the frame” (page 415). Ensure that the
resting position of the cable is still unstressed when the door is opened
fully.
11 Unlock the door lock by turning the key counter-clockwise until it is
horizontal as shown in the figure “A lockable vented door NTRU0423,
outside view” (page 411).
12 Verify the operation and position of the door by closing it. To engage the
upper and lower catches, lift the door handle and turn it to the left, then
push the door closed, and release the handle. A spring returns the handle
to the starting position. Refer to the figure “A lockable vented door
NTRU0423, outside view” (page 411). While closing the door, ensure that
the ground cable is not rubbed or pinched. Dress the cable as required.
Pull on each corner of the door on the lock side to ensure that the catches
have engaged.
13 As required, lock the door by turning the key clockwise until it is vertical.
14 Store the door keys according to your company’s security policies.