Nortel N0060609, Installation Manual

Page: 64 / 84

64 Chapter 9 Registering Nortel 20XX and 11XX IP telephones
N0060609 0.3 N0060609 0.3
NETMASK <subnet mask
address> This is the subnet mask. This setting is critical for locating the system to
which you want to connect.
DEF GW <IP address> Default Gateway on the network (for example, the nearest router to the
telephone. The router for IP address W.X.Y.Z is usually at W.X.Y.1).
If there are no routers between the telephone and the system network
adaptor to which it is connected, (for example, a direct HUB
connection), then enter the Published IP address of the BCM as the
DEF GW.
If the IP telephone is not connected directly to the Published IP address
network adapter, set the DEF GW to the IP address of the network
adaptor to which the telephone is connected.
Emulation Key
Mapping 0 or 1 0 = Handset
1= Handsfree
Default setting is 1 (handsfree) and should not be changed.
Note : This setting applies to the 2033 model only.
If DHCP = 1
Manual Cfg?
DHCP:
Full = 0
Partial = 1
If you indicate DHCP for the telephone, but you want to enter static
IP addresses, choose 1 (Partial).
If you choose 0 (Full), the DHCP server assigns IP addresses that are
not static.
If DHCP = 0 or Partial
S1 IP <IP address> This is the Published IP address of the first system to which you want to
register the telephone.
S1 PORT Default: *7000 This is the port the telephone uses to access this system.
S1 ACTION Default: 1
S1 RETRY COUNT <digits between 0
and 255> Set this to the number of times you want the telephone to retry the
connection to the system.
S2 IP <IP address> This is the Published IP address of the second system to which you
want to register the telephone. It can be the same as the S1 setting.
S2 PORT Default: *7000 This is the port the telephone uses to access this system.
S2 ACTION Default: 1
S2 RETRY COUNT <digits between 0
and 255> Set this to the number of times you want the telephone to retry the
connection to the system.
VLAN 0: No VLAN
1: Manual VLAN
2: Automatically
discover VLAN
using DHCP
Choose 0: NO VLAN if there is no VLAN on the network.
If you do not have DHCP on the network, or if DHCP is supplied by a
remote server, select number 1 and enter the VLAN ID*.
If you have the system DHCP active on your system, select number 2 if
you want DHCP to find the VLAN assignment automatically.
*VLAN is a network routing feature provided by specific types of
switches. To find out if VLAN has been deployed on your system, check
with your network administrator. If VLAN is deployed, the system
administrator responsible for the switch can provide the VLAN IDs for
your system.
Cfg XAS? 0: No (default)
1: Yes
If you want to enable connection to a Net6 service provider server,
choose 1. You are then prompted for an IP address for the server.
* Firewall note: Ensure that the firewall filters are set up to allow IP traffic into and out of the system.
Table 7 IP telephone server configurations (Sheet 2 of 2)
Field Value Description