Mounting the terminal 2-9
Mounting and connecting the terminal
CAUTION
•
The Millennium multi-pay terminal must
be mounted on a vertical surface.
/ l \
•
A tilt greater than 1.5 degrees in any di
rection may cause malfunction.
The following procedures describe how to install a
Millennium multi-pay terminal in a variety of furniture.
Installing the terminal in recessed furniture
Most manufactured enclosures come with a backboard
installed. As you prepare to install the terminal, you will have
two considerations:
1. W hether the backboard hole pattern fits the pattern on
the terminal.
2. W hether the terminal will require spacers to bring it for
ward so it is accessible for use and maintenance. This
is not a likely problem with the multi-pay terminal, as it
is fairly deep. But the key lock and the aperture for the
T- or L-tool must be accessible.
If either of these conditions need addressing, an adapter kit
can be ordered from the manufacturer of the enclosure.
Use the instructions included with the adaptor to install the
kit.
Then install the terminal onto the backboard. Refer to the
procedure in
Installation in a non-recessed area,
in the
next section.
Millennium multi-pay terminal installation, operation, and maintenance guide
Summary of Contents for Millennium multi-pay M1211
