Nortel Meridian Meridian 1, Planning, Installation And Operating Instructions

Page: 260 / 556

Chapter 20 — Meridian Mail Compact Option installation and maintenance Page 241 of 536
Option 11C Compact Planning, Installation, Fault Clearing and CCBR Guide
Assigning the dataport locations
To assign dataport locations to your system, follow these steps.
Step Action
1 From the previous procedure.
Select Yes, then press <Return>.
Result The dataport configuration table is displayed. The following
shows the default settings for a basic Meridian Mail Compact Option
system.
Node Card Type Port 1 Port 2 Port 3 Port 4
1 1 ESBC CONSOLE CLS1 DIAGNOST
------------------------------------------------------------
Please assign the data port locations.
Select operation : Display
The following shows the default settings for a Meridian Mail Compact
Option system running HVS.
Node Card Type Port 1 Port 2 Port 3 Port 4
1 1 ESBC CONSOLE CLS1
1 4 RSM MOD0131 PRT0132 PMS0143 PMS0143
------------------------------------------------------------
Please assign the data port locations.
Select operation : Display
Meridian Mail Compact Option systems can have up to six data ports:
the first two are reserved for the system administration terminal and the
link to the Meridian 1 switch, the third is reserved for the RS-232 port on
the faceplate of the Meridian Mail Compact Option CPU card, and the
remaining three are the three ports available on the RSM Assembly
Module, if one is installed.
On basic systems, the RS-232 port on the faceplate of the Meridian
Mail Compact Option CPU card is generally used to connect a
diagnostic terminal to Meridian Mail. On HVS systems, the software
considers this port a virtual port on the RSM Assembly Module and
allows you to configure it for a second GAC terminal.