Nortel LinkPlexer, Installation And Configuration Manual, Page: 57 / 196

Installation and Configuration Guide 57
October 2007 Installing LinkPlexer 6.0
Installing the iButton software and hardware
Introduction
In addition to the LinkPlexer 6.0 software, Nortel provides an iButton and a
USB adapter for mounting the iButton on the server, a keycode specific to the
iButton, and Dallas Semiconductor 1-Wire drivers.
To install the 1-Wire iButton drivers
1 Remove any 1-Wire USB devices that are plugged in an available USB port
of the LinkPlexer 6.0 server. Leave any non-USB devices plugged in.
2 Insert the DVD containing LinkPlexer 6.0 into the DVD drive and using
Windows Explorer, launch the installation package
<DVD
DRIVE>:\LinkPlexer\ThirdParty\install_1_wire_drivers_v400.msi . You
can also obtain the 1-Wire drivers from the following Web site:
ATTENTION
The iButton hardware and software installation is only
necessary if you are using the iButton for software control and
licensing. If you are using Nortel License Manager, you can
omit this procedure. However, you must install LinkPlexer
SU01 to take advantage of the License Manager technology.