Nortel Contivity 100, Setting Up, Page: 65 / 78

Chapter 6 Out-of-band management support 65
Setting Up the Contivity 100 Unit
Figure 11 HyperTerminal COM1 Properties dialog box
6
From the Bits per second list, select 115200 to set the connection speed, and
then click OK.
HyperTerminal establishes a connection to the unit. If your unit is password
protected, the session begins by requesting a password. Enter the password
for the unit and then press [Enter].
If you enter an incorrect password, the message “Incorrect Login” is
displayed and you are prompted to enter a correct password. You are given
two more chances before the Contivity 100 unit ends the session and
disconnects you.
When you successfully log on, the command prompt is displayed (Figure 12) and
you can begin using CLI commands to configure the unit. For details, refer to
Reference for the Contivity Branch Access Command Line Interface Version 7.20.
Note: The connection speed should match the unit’s AUX port
connection speed. If you are using terminal emulation software that does
not support 115200 baud, select 9600 baud.