Nortel Contivity 100, Setting Up

Page: 38 / 78

38 Chapter 2 Contivity 100 unit hardware installation
313369-A
Mounting your Contivity 100 unit on a wall
You can mount the Contivity 100 unit on any drywall, wood, or cement wall that
is at least 0.39 inches (10 mm) thick and is capable of supporting the combined
weight of the unit and attached cables (approximately 11 pounds or 5 kg).
A set of brackets, self-tapping (3.5x16) drywall screws, and (3x18) plastic
expansion lugs
(Figure 3) has been included with the Contivity 100 unit. You will
also need a pencil and a Phillips screwdriver, which are not included with the unit.
Caution: The screws and wall composition must be able to withstand
the weight of the device, plus the additional weight of the attached
network cables and power cords.
Achtung: Schrauben und Wand müssen so beschaffen sein, daß sie dem
Gewicht des Geräts, zuzüglich des Gewichts der angeschlossenen
Netzwerk- und Netzstromkabel, standhalten können.
Attention: Les vis de fixation et le mur doivent être capables de
supporter le poids du dispositif, ainsi que des câbles réseau et cordons
qui y sont rattachés.
Attenzione: Le viti e la struttura a muro devono essere in grado di
sostenere il peso del dispositivo, oltre a quello dei cavi di rete e di
alimentazione collegati.
Precaución: Los tornillos y la composición de la pared deben ser
capaces de sostener el peso del dispositivo más el peso adicional de los
cables de red y cables de alimentación conectados.