Nortel CallPilot 702t, Installation And Configuration Manual

Page: 257 / 306

October 2002 Replacing network cards
Part 5: 702t Server Maintenance and Diagnostics 257
Replacing the CLAN card
Introduction
The CLAN card is an expansion card installed in a PCI slot. A CLAN
network is required to support Unified Messaging applications.
To replace the CLAN card
1 Power down the server.
2 Unplug the AC power cord.
3 Remove the chassis cover.
4 To make access to the internal components easier, turn the server over
on its side.
5 Locate the CLAN Ethernet card to be removed, and unplug its network
cabling.
6 Remove the screw that fastens the card in the chassis.
7 Gently pull the card out (use a slight rocking motion).
8 Remove the new Ethernet card from its protective packaging.
Note: Place the old Ethernet card into the protective packaging.
9 Line up the new Ethernet card with the slot (PCI or ISA, as appropriate).
Note: Make sure the end-plate tab is lined up with the opening in the
chassis.
10 Press the card into the slot.
11 Secure the card to the server chassis with the fastening screw.
.
CAUTION
Risk of equipment damage
Ensure that the card is completely seated or it will short-circuit.