Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 66 / 368

Using serial port diagnostic tools Standard 1.0
66 CallPilot
Routing and Remote Access Service
Net Stop command
Use the Net Stop command to stop a specified service on a serial port.
NET STOP command syntax
The Net Stop command uses the following syntax:
net stop “ service_name ”
To invoke the Net Stop command from Windows NT 4.0
1 Click Start
➝
Programs
➝
Command Prompt to display the MS-DOS
command prompt window.
Result: The MS-DOS Command Prompt window appears.
2 At the MS-DOS prompt, type net stop “ service_name ”, and then press
Enter.
For example, type net stop “Routing and Remote Access Service”,
and then press Enter.
Note: The quotation marks are required, as in the example above.
Result: The system runs the net stop command utility.
3 Type Exit , and then press Enter to exit MS-DOS.
ATTENTION
You must restart the services that you shut down through
the Net Start command after running the diagnostic. For
details, see “Restarting services” on page 72.