Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 347 / 368

October 2002 Maintaining the Pentium III SBC card
Part 5: 1001rp Server Maintenance and Diagnostics 347
3 Hold the DIMM by its edges, being careful not to touch its components.
Remove the DIMM by lifting it away from its slot. Store it in an antistatic
package.
4 Remove other DIMMs as necessary.
5 Orient the DIMM so that the two notches in the bottom edge of the DIMM
align with the keyed slot.
6 Insert the bottom edge of the DIMM into the slot, and press down firmly
on the DIMM until it seats correctly.
When the DIMM seats correctly, release tabs lock back to an upright
position. If the DIMM does not seat correctly, remove it and reinstall. Do
not force the locking tabs to close.
7 Repeat the above two steps to install each additional DIMM.
8 Replace the SBC card in the server.
.
CAUTION
Risk of equipment damage
When installing a DIMM in slot 1, the IDE locking latch may get
in the way and cause a memory chip to snap out of the board.