Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 289 / 368

October 2002 Replacing the network cards
Part 5: 1001rp Server Maintenance and Diagnostics 289
14 Replace the chassis covers.
15 Plug in the AC power cord.
16 Power up the server.
To install a 3Com PCI Ethernet network card driver
1 Start with Windows NT and log on to the server as Administrator .
2 Open the Network Control Panel, select the Adapters tab, and Click
Add... to add the adapter.
3 Click Have Disk... to load the device driver.
4 Insert the 3Com device driver disk for the CLAN card, and then press
Enter.
5 Select 3Com Fast Ethernet 3C900 card, and then click OK.
6 Click Close to close the network control panel and configure the network
card.
7 Enter the TCP/IP information for the card.
Note: The customer must provide this information.
8 Click OK to close the TCP/IP configuration screen.
9 Click Yes to restart the computer.
To replace an Intel PCI Ethernet card
1 See “Slot assignments” on page 354 to determine the proper slot
assignment for the CLAN card.
2 Check that the BIOS is configured to assign the correct IRQ to the
correct slots.
3 Power down the server.
4 Unplug the AC power cord.
5 Remove the chassis cover.
6 Locate the CLAN Ethernet card to be removed, and unplug its network
cabling.