Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 205 / 368

October 2002 Performing RAID maintenance
Part 5: 1001rp Server Maintenance and Diagnostics 205
10 Repeat steps 6 to 10 for the fifth and sixth hard drives.
Result: The pre-upgrade hard drives (fourth, fifth, and sixth) are offline.
11 Press Esc to return to the administration pop-up menu.
Result: You return to the administration pop-up menu.
12 Press Esc to return to the main menu.
Result: You return to the main menu.
13 Press Esc to return to the RAID controller selection window.
Result: You return to the RAID controller selection window.
14 Press Esc to exit the Mylex RAID EzAssist program.
Result: A message appears indicating that you are about to exit RAID
EzAssist and asking for confirmation.
15 Select Yes, and then press Enter.
Result: A message appears indicating that you can either power off the
system or select OK to reboot.
16 Power off the server.
To disconnect the secondary hard drives
Physically disconnect the secondary hard drives to ensure that these hard
drives are not updated during the upgrade and are preserved as a backup.
The disconnected hard drives are automatically marked as offline when you
restart the server.