Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 176 / 368

Performing RAID maintenance Standard 1.0
176 CallPilot
To cable hard disk drives in a RAID system
1 Connect a SCSI cable to Channel 1 on the RAID card.
2 Route the cable to the expansion card area through to the left side of the
system, and down to the SCSI backplane.
Result: The SCSI backplane provides termination for this SCSI channel.
To cable a RAID system for a tape drive
1 Connect a second SCSI cable to Channel 0 on the RAID card.
2 Route the cable between the RAID card and the right side of the system
chassis to the front of the chassis, and then down through the system to
the tape drive.
3 Attach a wide SCSI active terminator (A0766997) as the last device on
the cable.
Note: The NTRH9034 tape drive cannot provide SCSI bus termination.
You must have an Active SCSI terminator as the last device on the SCSI
cable. Ensure that the jumper labeled TPWR is enabled on the tape
drive. The tape drive must always be connected to the second last
connector on the SCSI cable.
What’s next?
Once you have installed and cabled the RAID card, power up the server. The
card reads the configuration from the drives and configures itself. If the
server does not start properly, contact your Nortel Networks technical
support representative.
.
CAUTION
Risk of equipment damage
Ensure that no cable touches any SBC card component. Heat
transfer often causes serious damage to the system.