Nortel BCM50e, Configuration

Page: 70 / 311

70 Chapter 6 Remote Node setup
N0115789
PPPoE Encapsulation
The Business Secure Router supports PPPoE (Point-to-Point Protocol over
Ethernet). You can only use PPPoE encapsulation when you are using the
Business Secure Router with a DSL modem as the WAN device. If you change
the Encapsulation to
PPPoE,
you then see Figure 20 . Please see Appendix E,
“PPPoE,” on page 227 for more information about PPPoE.
Service Name If you are using PPPoE encapsulation, then type the
name of your PPPoE service here. Only valid with
PPPoE encapsulation.
poellc
Outgoing
My Login This field is applicable for PPPoE encapsulation only.
Enter the logon name assigned by your ISP when the
Business Secure Router calls this remote node. Some
ISPs append this field to the Service Name field above
(e.g., jim@poellc) to access the PPPoE server.
jim
My Password Enter the password assigned by your ISP when the
Business Secure Router calls this remote node. Valid for
PPPoE encapsulation only.
*****
Retype to
Confirm
Type your password again to make sure that you have
entered it correctly.
*****
Server IP This field is valid only when Road Runner is selected in
the Service Type field. The Business Secure Router
finds the Road Runner Server IP automatically if this field
is left blank. If it does not, then you must enter the
authentication server IP address here.
Route This field refers to the protocol that is routed by your
Business Secure Router.
IP
Edit IP This field leads to a “hidden” menu. Press [SPACE BAR]
to select Yes and press [ENTER] to go to M enu 11.1.2 -
Remote Node Network Layer Options .
No
(default)
Session Options
Edit Filter sets This field leads to another “hidden” menu. Use
[SPACE BAR] to select Yes and press [ENTER] to open
menu 11.1.4 to edit the filter sets. See “Remote Node
filter” on page 77 for more details.
No
(default)
After you configure this menu, press [ENTER] at the
message “Press ENTER to Confirm...” to save your
configuration, or press [ESC] at any time to cancel.
Table 13 Fields in menu 11.1
Field Description Example