40
BCM450 expansion cabinet installation
Nortel Business Communications Manager 450 1.0
Installation — System
NN40160-301 01.04 Standard
July 2009
Copyright © 2006-2009 Nortel Networks
2
Install four #10 x 2.5 cm (#10 x 1 in.) round-head screws in the backboard.
Leave approximately 0.5 cm (0.25 in.) of each screw exposed from the
backboard (or wall).
3
Hang the wall-mount bracket on the installed screws.
4
Use a level to make sure the wall-mount bracket is level.
5
Remove the wall-mount bracket from the backboard.
6
Align the screw holes on one side of the BCM450 expansion cabinet with
the wall-mount bracket.
7
Fasten the wall-mount brackets securely to the BCM450 expansion cabinet
using the screws provided.
8
Hang the expansion cabinet on the backboard screws. Make sure the
expansion cabinet is level. Ensure the wood screw heads seat fully into the
wall-mount bracket slots.
9
Tighten the wood screws against the wall-mount bracket.
--End--
Installing the expansion cabinet on a desktop
If you cannot install your BCM450 expansion cabinet in an equipment rack or
on a wall, you can install your expansion cabinet on a desktop or shelf.
Prerequisites
•
Locate the four self-adhesive rubber feet.
•
Leave enough space around the expansion cabinet for ventilation and
access to the cables.
Procedure steps
Step
Action
1
Remove the paper backing from the four enclosed self-adhesive rubber feet.
2
Attach the four self-adhesive rubber feet to the bottom of the expansion
cabinet.
3
Position the expansion cabinet on a desktop or shelf.
--End--
Connecting the expansion cabinet to the main unit
Connect the expansion cabinet to the main unit to gain additional functionality
provided by the MBMs.
Summary of Contents for BayStack 450 Switch
Page 141: ......
