42
DC power supply installation
Figure 8
Removing a power filler panel: 8006 and 8010 chassis
Installing the DC power supply
Install the DC power supply to the DC input power source of the Ethernet
Routing Switch 8600.
Use the following procedure to install the DC power supply.
DANGER
Risk of electric shock
Before working on this equipment, be aware of proper safety
practices and the hazards involved with electrical circuits. Use
only power cords that have a grounding path. Ensure the switch
is properly grounded before powering on the unit.
Prerequisites
•
If you install a power supply in the 8010co chassis with bezel model
312096-A installed, you must remove the bottom front bezel.
For instructions, see
“Removing the bottom bezel 312096-A of the
.
Nortel Ethernet Routing Switch 8600
Installation — DC Power Supply
NN46205-307
02.02
19 December 2008
Copyright © 2008 Nortel Networks
.
Summary of Contents for 8004DC
Page 69: ......
