Nortel 703t, Maintenance And Diagnostics

Page: 27 / 248

January 2007 Troubleshooting your CallPilot system
703t Server Maintenance and Diagnostics 27
Hard drive LED states
The hard drive LED (the first LED in the row of LEDs below the power
button on the 703t server front panel) is not used because the 703t server
is actually equipped with two hard drives. There are no LEDs on the hard
drives.
If hard drive faults occur on the 703t server, you can investigate them by
reviewing events in the following:
„
operating system Event Viewer (see “Viewing event logs” on
page 48)
„
CallPilot Event Browser (see “Event Browser” on page 82)
You can also view the status of each hard drive in the MegaRAID Client.
For instructions on accessing and using this utility, see Chapter 10,
“RAID operations.”
on a valid hardware connection with the network has
been established.
Note: Before the 703t server can receive or
transmit data, you must configure valid IP
settings on the 703t server.
blinking rapidly activity is occurring on the network.
Note: This does not mean that the 703t server is
actually transmitting or receiving packets.
IF the network
interface LED is
THEN