Nortel 703t, Maintenance And Diagnostics

Page: 200 / 248

Working with DIMMs and the CPU Standard 1.06
200 CallPilot
To remove baseboard DIMMs
1 Prepare the server for DIMM replacement as follows:
a. Shut down the server, and then disconnect the power and
peripheral device cables.
b. Place the server on its side.
c. Remove the side cover.
For instructions, see “Preparing the server for hardware
maintenance” on page 120.
2 Gently push the plastic ejector levers of the DIMM socket out and
down to eject a DIMM from its socket.
3 Hold the DIMM only by its edges; be careful not to touch its
components or gold-edge connectors. Carefully lift it away from the
socket, and store it in an antistatic package.
4 Repeat to remove other DIMMs as necessary.
5 If you are replacing a DIMM, continue with “To install baseboard
DIMMs” on page 201.
.
WARNING
Risk of personal injury or equipment damage
Failure to follow the procedures in “Preparing the
server for hardware maintenance” on page 120 can
result in electrical shock or equipment damage.
.
CAUTION
Risk of equipment damage
Use extreme care when removing a DIMM. Too much
pressure can damage the socket slot. Apply only
enough pressure on the plastic ejector levers to
release the DIMM.