Nortel 703t, Maintenance And Diagnostics

Page: 156 / 248

Replacing media drives Standard 1.06
156 CallPilot
Replacing the tape drive
The tape drive is preinstalled at the factory. However, if it becomes
faulty, follow the procedure in this section to replace it.
Filler panels and EMI shields
System EMI integrity and cooling are both protected by drives installed
in the bays or by filler panels and EMI shields covering the bays. When
installing drives, save the panel and shield to reinstall later, in case you
remove the drive and do not reinstall one in the same bay.
Tape drive configuration
Note: Some settings may already be properly configured. If it is not clear
from the drive manufacturer’s documentation how to set jumpers,
contact your Nortel technical support representative.
Ensure that the hard drives are configured as follows (for instructions,
refer to the original equipment manufacturer documentation):
„
SCSI ID: 2
„
active terminators (Term Enable): disabled
Note: Termination is provided by an Active SCSI terminator that
you connect to the end of the SCSI cable (see “SCSI and IDE drive
cabling” on page 146).
.
CAUTION
Risk of electrical damage
Use only a tape drive that is supplied by Nortel.