Nortel Ethernet Routing Switch 5500 Series Stack Configuration
53
•
"Abandoning a command" (page 54)
Setting the Base Unit
To set the stack base unit with the UI button, follow
this procedure:
Step
Action
1
Press and hold the UI button for three seconds.
The unit is now in configuration mode. The color and status of the
Status LED turns to blinking green.
2
Press the UI button once.
The Base LED is illuminated and the Up and Down LEDs are steady
green to indicate that the button press was recognized.
3
Press and hold the UI button for three seconds to confirm the
command.
The Status LED returns to a steady green state to confirm command
acceptance. If the command is rejected, the Status LED moves
to a blinking amber state.
—End—
Note: The switch does not become the base unit until the next time the
switch is restarted.
Setting the Non-Base Units
To set the stack non-base units with the UI
button, follow this procedure:
Step
Action
1
Press and hold the UI button for three seconds.
The unit is now in configuration mode. The color and status of the
Status LED turns to blinking green.
2
Press the UI button twice.
The Base LED will turn off and the Up and Down LEDs will move
to a steady green state.
3
Press and hold the UI button for three seconds to confirm the
commands.
The Status LED returns to a steady green state to confirm command
acceptance. If the command is rejected, the Status LED moves
to a blinking amber state.
Nortel Ethernet Routing Switch 5500 Series
Installation
NN47200-300
2.00
Standard
5.0
7 July 2006
Copyright © 2005 - 2006, Nortel Networks
Nortel Networks Confidential
.