40
Installing the Nortel Ethernet Routing Switch
The Read-Only Community String prompt line appears
Please provide the Read-Only Community
String[**********]:******
The confirm Read-Only Community String prompt line appears
Please confirm the Read-Only Community
String[**********]:******
The Read-Write Community String prompt line appears
Please provide the Read-Write Community
String[**********]:*******
The confirm Read-Write Community String prompt line appears
Please confirm the Read-Write Community
String[**********]:*******
The Quick Start VLAN prompt line appears
Please provide the Quick Start VLAN <1-4094> [1]:
The Basic Switch parameters configuration confirmation appears
Basic switch parameters have now been configured and
saved.
—End—
Note: Nortel Ethernet Routing Switch 4500 Series console port
supports Nortel CLI only. When the switch is set to factory default
parameters, the CLI Quickstart displays.
Setting IP parameters using the console port and CLI
If the switch is configured beyond factory default settings, perform the
following procedure to set IP parameters using the console port and
Command Line Interface (CLI):
Step
Action
1
Connect a terminal to the console port of the switch. Any terminal
or PC with an appropriate terminal emulator can be used as the
management station. See
"Setting IP parameters using the console
port and CLI Quickstart" (page 38)
.
2
Set the terminal protocol on the terminal or terminal emulation
program to VT100 or VT100/ANSI.
Nortel Ethernet Routing Switch 4500 Series
Installation Guide
NN47205-300
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
Summary of Contents for 4500 Series
Page 59: ......
