Nortel 425-24T, Configuration Manual, Page: 134 / 488

134 Chapter 3 CLI Basics
320985-A Rev 01
end command
The
end
command moves you to the priv Exec mode from either the Global
Configuration (config) mode or the Interface Configuration (config-if) mode.
The syntax for the
end
command is:
end
The
end
command has no parameters or variables.
exit command
The
exit
command moves you around the command modes:
• In User EXEC (exec) and Privileged EXEC (privExec) command modes,
exit
allows you to quit the CLI session.
• In Global Configuration (config) mode,
exit
moves you back to the privExec
command mode.
• In Interface Configuration (config-if) command mode,
exit
moves you back
to the config mode.
The syntax for the
exit
command is:
exit
The
exit
command has no parameters or variables.
shutdown command for the unit
The
shutdown
command allows you to safely shut down and power off the
switch. Once the
shutdown
command is initiated, the switch saves the current
configuration which allows users to power off the switch within the specified time
period (1 to 60 minutes); otherwise, the switch performs a reset.
When the
shutdown
command is initiated in the CLI, the following message
appears:
Shutdown (y/n) ?