Nortel 1002rp, Maintenance And Diagnostics

Page: 54 / 218

Using serial port diagnostic tools Standard 1.11
54 CallPilot
Net Stop command
Use the Net Stop command to stop a specified service on a serial port.
Net stop command syntax
The Net Stop command uses the following syntax:
net stop <service_name>
To invoke the Net Stop command from Windows
1 Click Start
➝
Programs
➝
Accessories
➝
Command Prompt.
Result: The Command Prompt window appears.
2 At the Command prompt, type net stop “ service_name ” , and then
press Enter.
Note: The quotation marks are required, as in the example above.
Result: The system runs the Net Stop command utility.
3 Type Exit , and then press Enter to exit the Command Prompt
window.
Service Control (SC) command
Use the Service Control command to stop a specified service on a serial
port.
Service Control command syntax
The Service Control command uses the following syntax:
ATTENTION
You must restart the services that you shut down
through the Net Start command after you run the
diagnostic. For details, see “Restarting services” on
page 61.