Nortel 1002rp, Maintenance And Diagnostics

Page: 44 / 218

Using Windows online diagnostic tools Standard 1.11
44 CallPilot
To run the arp command from Windows
1 Click Start
➝
Programs
➝
Accessories
➝
Command Prompt.
Result: The Command Prompt window appears.
2 At the Command prompt, type arp with the required parameters (for
example, arp -g 200.286.0.32).
3 Press Enter.
Result: The system runs the arp command.
4 Type Exit to exit the Command Prompt window and return to
Windows.
The nbtstat command
The nbtstat command displays protocol statistics and current TCP/IP
connections using NBT.
Nbtstat command syntax
The nbtstat command uses the following syntax:
nbtstat [-a remotename] [-A IP address] [-c] [-n]
[-R] [-r] [-S] [-s] [interval]
-N if_addr Displays the arp entries for the network interface
specified by if_addr.
-d Deletes the host specified by inet_addr.
-s Adds the host and associates the Internet address
inet_addr with the physical address eth_addr. The
physical address is given as six hexadecimal bytes
separated by hyphens. The entry is permanent.
Parameter Description