Nortel 1002rp, Maintenance And Diagnostics

Page: 42 / 218

Using Windows online diagnostic tools Standard 1.11
42 CallPilot
Tracert syntax
The tracert command uses the following syntax:
tracert [-d] [-h maximum_hops] [-j host_list]
[-w timeout] [target_name]
Tracert parameters
the following table shows the tracert parameters.
Table 4: Tracert parameters
To run the tracert command from Windows
1 Click Start
➝
Programs
➝
Accessories
➝
Command Prompt.
Result: The Command Prompt window appears.
2 At the Command prompt, type the following command:
tracert [-d] [-h maximum_hops] [-j host_list] [-w timeout]
[target_name]
Example: tracert 200.286.0.32
3 Press Enter.
Parameter Description
-d Specifies not to resolve addresses to hostnames.
-h maximum_hops Specifies the maximum number of hops to search
for the target.
-j host-list Specifies a loose source route along the host list.
-w timeout Waits the number of milliseconds specified by the
timeout for each reply.
target_name Specifies the name of the target host.