Nortel 1002rp, Maintenance And Diagnostics

Page: 163 / 218

January 2007 RAID operations
1002rp Server Maintenance and Diagnostics 163
Configuring the RAID controller after a
hardware change
The RAID card’s configuration is stored on both the card and on the hard
drive, so typically you are not required to reconfigure RAID unless you
are making a change to the RAID system (for example, if you replace the
hard drives with higher-capacity hard drives).
To configure an LSI Elite 1600 or LSI320-2 RAID
system
1 Turn on the server and press Ctrl+M when prompted during system
bootup.
Note: The Ctrl+M utility can take up to 1 minute to launch. The
system may appear frozen. Do not reset.
2 From the Management menu, select Objects and press Enter.
.
CAUTION
Risk of data loss
This procedure requires that the logical drive be initialized.
When you initialize the logical drive, all data on the hard drives
is erased.
Do not perform this procedure unless you are replacing the
hard drives, or you are rebuilding the CallPilot system (that is,
reinstalling the Windows operating system and CallPilot
software).
WARNING
Nortel strongly recommends that you not perform low
level formatting. Performing low level formatting results
in the drives becoming unusable.