Nortel 1002rp, Maintenance And Diagnostics

Page: 130 / 218

Replacing basic chassis components Standard 1.11
130 CallPilot
Figure 23: Fuse receptacle
5 Slide the fuse receptacle out of the fuse chamber.
Note: Observe how the blown fuse is positioned in the receptacle.
6 Remove the blown fuse from the fuse receptacle.
7 Install the approved replacement fuse. Use a flat-blade screwdriver
to screw in the fuse receptacle with a push and 1/4 clockwise turn.
8 Slide the fuse receptacle back into its chamber.
9 Fasten the fuse receptacle with a flat-blade screwdriver.
10 Plug the power cable back into the power input socket on the
server.
11 Plug the power cable into the wall outlet.
12 Power on the server.
ATTENTION
If the fuse blows after replacement, swap one power
supply module with the other. If this does not work,
call your Nortel customer support representative.
Fuse
G101732
A