16
c
DOC-000898 Rev B 07/2020
6. Install the remaining petals in increasing order by performing the steps below:
a. Adjust the elevation angle as needed to access the hub-side latches.
b. Insert the locating stub on the petal into the mating slot in the Reflector Hub and any adjacent petals.
c. Engage all petal-side latches.
d. Engage all hub-side latches.
Note: If the polarization assembly is blocking the hub-side latches, refer to Section 5.3.3 to adjust the
position of the polarization assembly.
4.3.3. Feed
1. Take out the Feed Horn from Case 1
2. Install onto the Pedestal by rotating the Feed Collar along the threads on the Pedestal
Note: Feed Horn can be installed onto the Pedestal in any orientation.
Feed Collar
