Recommended Tools
Power drill & Drill bit
Tape measure
Screwdriver
Level
Pencil
Centerpiece
TM
Roman Shade
Installation Instructions
N300615-1
Please take a moment to review the
following installation guide.
Please leave shade in folded open
position for ease of installation.
Be sure to keep all components and
packaging until shade is fully installed.
Motorized
Motorized Dual
Motorized & Motorized Dual outside mount default
Shade Width
Bracket
1 1/2" Screw
20"
≦
X
≦
52"
2pcs
4pcs
52"
<
X
≦
96"
3pcs
6pcs
Motorized & Motorized Dual inside mount
Shade Width
Bracket
1 1/2" Screw
20"
≦
X
≦
52"
2pcs
2pcs
52"
<
X
≦
96"
3pcs
3pcs
Hardware Included
1.
Mounting the shade inside a
window frame
Bracket
Evenly
spaced
Evenly
spaced
3.5"
3.5"
Fasteners needed for different mounting surfaces:
Fastener
1 1/2" Screw (Provided)
Wall Anchors, Expansion Bolts
(Not Provided)
Sheet Metal Screws
(Not Provided)
Wood
Drywall/Plaster
Metal
Mounting Surface
Note:
If spacer block is required, please
install it as above picture.
Motorized & Motorized Dual outside mount optional
Shade Width
Bracket
2 1/2
"
Screw
Spacer Block
20"
≦
X
≦
52" 2pcs
4pcs
1 or 2sets
52"
<
X
≦
96" 3pcs
6pcs
1 or 2sets
For motorized dual
The combination of brackets and spacer block
is used as brackets and also center support if
applicable. Put the spacer block at the back
of the bracket as pictured below, and then
attach the combination with 2pcs 2.5" screws.
Step 1:
Mark both side-headrail marks centered
along the top of the window frame.
Step 2:
Mark the screw positions where you will
install the brackets, 3.5” from each side of the
shade.
Step 3:
The bracket must be evenly spaced if
more than two brackets are required. Every
bracket is fixed with one 1 1/2" screw.
Step 4:
Mounting the brackets
When flush inside mount, allocate a min.
distance of 1 3/8” for motorized, while 2” for
Motorized Dual from the edge of the wall to the
center of the screw hole.
For motorized
Attach the bracket with 2 pcs 1 1/2" screws on
the wall directly.
2.
Mounting the shade outside
a window frame
Step 1:
Determine a desired position of the shade
and mark the top of shade and both side-headrail
marks. The top-of-shade mark is at least 2” from
the top edge of window frame.
Step 2:
Use the template provided to mark the
screw hole position for bracket at both ends.
Step 3:
The bracket must be evenly spaced if
more than two brackets are required.
Step 4:
Mounting the brackets.
Motorized Dual
motorized
