RV Series Automated Dispensing Systems
55
www.nordsonefd.com [email protected]
+1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
Robot Initial Setup (Step 5 Tab): Setting the Tip-to-Workpiece Offset
#
Click
Step
Reference Image
1
• Ensure that the STEP5 tab is open.
2
• Jog the tip to a good reference point on the
workpiece.
• Jog the tip down until it is as close to the
workpiece as possible without touching the
surface.
3
• Using a feeler gauge, set the desired
distance between the bottom of the tip and
the workpiece.
4
• Click SET WORKPIECE SURFACE.
5
• Click FOCUS.
The tip moves to the correct focus height.
• Click NEXT.
6
• Continue to “Robot Initial Setup (Step 6
Tab): Testing the System Setup and
Calibration” on page 56.
Setting Up the System Using the Robot Initial Setup Wizard (continued)
