Applicators PatternCoat
15
P/N 7135308_08
E
2014 Nordson Corporation
PatternCoat
Operation
WARNING:
Allow only qualified personnel to perform the following tasks.
Observe and follow the safety instructions in this document and all other
related documentation.
Triggering Solenoid Valves
CAUTION:
Observe the installation instructions: Refer to page
, Solenoid
Valves
.
The solenoid valves for the control modules are usually triggered by a control
unit (e.g.
Eclipse
). Refer to separate control unit manual.
CAUTION:
Trigger the solenoid valve only when the applicator is heated to
operating temperature! Seals in the control module can become damaged if
the adhesive is too cold.
Setting Temperatures
The procedure for setting the temperatures is described in the temperature
controller manual. Temperature controllers are not part of the applicator.
They can be located e.g. in the electrical cabinet of the melter or in a
separate electrical cabinet.
Maximum Operating Temperature
200 °C / 392 °F.
NOTE:
The maximum operating temperature may not be exceeded.
Nordson will assume no warranty or liability for damage resulting from
incorrect temperature settings.
Summary of Contents for PatternCoat Series
Page 30: ......
