Nordson iDry
r
Series Induction Dryers
9
Part 1075452
−
04
E
2016 Nordson Corporation
Installation
WARNING:
Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Inspection
The iDry system is shipped fully assembled, except for the glass coil tube
and coil, which are packed separately to prevent breakage. Unpack and
carefully inspect the dryer, coil tube, and coil for obvious shipping damage
and shortages. If you see any damage or shortages, notify the shipper and
your Nordson representative immediately.
NOTE:
A
5
/
16
inch hex wrench is required to unlock and lock the coil tray lid
and control enclosure doors.
Lift Points
CAUTION:
Never lift or move dryers with the glass coil tube installed. If
installed, remove the coil tube before lifting and moving dryer. When lifting
dryers with tandem coil trays (iDry 6 through iDry 9), both coil trays must be
supported.
Lift points with or without Magnetic Separator
Lift Point
Lift Point
0N
CH
AL
Figure 6
Lift Points for iDry Series Induction Dryer (Shown with Optional Magnetic Separator)