Nordson Encore XL Powder, Manual

Page: 101 / 155

© 2021 Nordson Corporation
1607027-01
8-27 Repair
5. Remove the bearing plate (4).
6.
Remove the hex screws (5) and the old fluid plate (6).
7. On the bottom of the new fluid plate, place gaskets according to dimensions shown
to properly align with holes. Apply instant bond adhesive to the seams of installed
gaskets.
8. Install new fluid plate (6) under clamp brackets (3). Then, place the bearing plate (4)
under the clamp brackets and on top of the fluid plate.
9. Tight the clamp brackets down with the jack screws (2).
10. Place the access panel (1) back onto the feed center.
Bottom of Fluid Plate
4
5
6
7
Apply bond adhesive to
seams of gaskets.
42.50 in.
(1080 mm)
19.63 in.
(499 mm)
Figure 8-22 Waste Hopper Fluid Plate Replacement (2 of 2)
4. Bearing plate
5. Hex screws 6. Fluid plate 7. Gaskets