Instruction Sheet
P/N 1124828
11/2015
Spectra™ 30 External Power Supply Kit - P/N 1124820
This instruction sheet describes how to connect the external power supply
in the Spectra 30 pattern controller.
WARNING:
Risk of personal injury or equipment damage! Refer to
the safety information provided in the melter manual before servicing
the melter. Failure to comply with the safety information provided can
result in personal injury, including death.
Required Tools:
Small Phillips screwdriver
Small and large flat screwdriver
External Power Supply
External Power Supply Connections
Continue
1.
Turn off the pattern controller switch and disconnect the input power
supply.
2.
Mount the external power supply (see
b
in Figure 1) as close as
possible to the pattern controller.
Figure 1
a
Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or
inexperienced personnel to operate or service the equipment can
result in injury, including death, to themselves and others, and
damage to the equipment.
Warning:
a: Four M5 captive screws
b: External power supply
c: DC Output terminal
d: AC Input terminal
e: Control board
d
c
b
e
3.
Unfasten the four captive screws (see
a
in Figure 1). Remove the
pattern controller front cover to access the control board (see
e
in
Figure 1).
4.
Route the cables through the conduits (see
c
and
d
in Figure 1)
located on the base panel of the pattern controller.
Remove one of the conduit fittings from the base panel of the pattern
controller to make room for the fitting attached to the power supply
cable.
