The Ultimus IV Dispensing System includes pre-set specifications based on industry-standard Nordson EFD syringe
barrel dimensions. In most cases, you will want to use these pre-set specifications. However, you have the option to
adjust the settings with the Modify function.
Follow these steps to use the Modify function:
1. From either the PROGRAMMED DISPENSE mode or the MANUAL mode, press the Single Barrel Select button.
The MOD (Modify) option will appear.
2. If needed, press F1 to highlight the syringe barrel size. Use the (+) or (-) buttons to select the correct barrel size
— for example, 3cc, 5cc, 10cc, or 30cc.
3. Press F4. This activates the Modify screen.
4. Press F3 to highlight the specifications for the diameter of the syringe barrel. This is displayed in centimeters.
The settings will vary according to the syringe barrel size you have selected. Use the (+) or (-) buttons to adjust
as needed.
5. Press F4 to highlight the specifications for the stroke of the syringe barrel, also listed in centimeters. Again, the
settings will vary depending on the syringe barrel size you have selected. Use the (+) or (-) buttons to adjust as
needed.
NOTE:
The stroke should reflect the distance the Nordson EFD piston will travel to dispense all of the fluid in
the syringe barrel. For example, if the barrel is loaded half-full, a certain stroke length (measured in centimeters)
will be required to empty it. By adjusting the stroke for a specific barrel fill level, you will ensure that the “Level”
display on the Home screen provides an accurate reading.
6. When finished, press the foot pedal once to return to the Home screen.
Modify Function
Barrel
select
Manual /
programmed
dispense select
Home
Shot count /
Volume
Reset
shot count
Decrease
Increase
F1
F3
F4
1 2.265 7.60
30cc Dia Strk
Ultimus IV Series Dispensers
23
www.nordsonefd.com [email protected]
+1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
