Liquidyn V10D Controller
10
www.nordsonefd.com [email protected]
800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
Equipment-Specific Safety Information
The following safety information is specific to the Liquidyn V10D controller.
Do not dry cycle the valve!
The valve can be damaged if it is operated without fluid, causing leakage and a poor
seal. Precise dispensing can no longer be guaranteed if this occurs.
CAUTION
General
• Before use, read the complete operating instructions and all safety instructions to ensure safe and correct usage.
• Observe all safety instructions.
Intended Use
• The micro-dispensing system is for indoor use only.
• Do not use the micro-dispensing system in an explosive atmosphere or with explosive materials.
• Do not expose the controller to direct heat sources.
Fluid Compatibility
• Use only for the micro-dispensing of high- to low-viscosity fluids or pastes.
• Ensure that all fluid carrying parts and sealings are resistant to the dispensing material used.
Operating Conditions
• Do not subject the valve needle to force, knocks, or impact.
• Avoid long shutdown periods with the system switched on.
• Do not operate the valve in a dry condition (without dispensing material).
Controller Operation
• Operate the controller only when it is in good working order and in accordance with the operating conditions
specified above.
• Operate the controller only when all safety devices and safety components are installed correctly and fully
functional.
Controller Faults
In the event of a fault in the power supply and / or damage to the electrical equipment, do the following:
1. Immediately switch OFF the controller and lock out electrical power to the controller.
2. Determine the cause of the fault condition and immediately rectify.
Nordson EFD Product Safety Statement (continued)
