Q
KORE
1
The Q
KORE
1 is intended to be connected to your Q
BASE unit
, using the
provided banana to banana Q
KORE
Wire. The Q
KORE
Wire should be inserted
into the Q
BASE
grounding post and the Q
KORE
’s dedicated Q
BASE
Ground
binding post.
Please note, while it is possible to connect two wires to each binding post,
using both a spade and banana connector, the results will not be as effective as
connecting them to two separate binding posts.
CONNECTING THE Q
KORE
Q
KORE
3
First, connect the Q
KORE
3 unit with your preamplifier using the provided
banana to RCA Q
KORE
Wire. The Q
KORE
Wire should be inserted into any
spare input or output on your preamplifier and any binding post on your
Q
KORE
3. Results may vary between different available outlets, so users
should experiment in order to determine which outlets work best for their
system. Next, ground your source component, followed by any remaining
components. Additional Q
KORE
Wires are available for purchase.
Note: The Q
KORE
3 is NOT intended for use with Q
BASE
units. Q
BASE
units should
be grounded to the dedicated “Q
BASE
Ground” binding post found on the Q
KORE
1
and Q
KORE
6.
!
Do NOT connect banana/spade terminations to speaker outputs.
This could result in a short circuit to your amplifier. Only connect
banana/spade ends of your Q
KORE
Wire to your Q
BASE
or Q
KORE
.
Summary of Contents for QRT QKORE1
Page 1: ...QKORE INSTRUCTION MANUAL...
Page 7: ......
