12
10
25
2
7
7
7
4
4
11
3
4
2
1
12
10. Untie and discard the wire tie on the Main Wire
Harness (25). Route the Main Wire Harness
upward through the Handlebar (4) as shown.
While a second person holds the Console (7)
near the Handlebar (4), plug the Main Wire
Harness (25) and the Pulse Wire Harness (23)
into the receptacles on the Console.
The connectors on the Main Wire Harness
(25) and the Pulse Wire Harness (23) should
slide easily into the receptacles and snap
into place. If a connector does not slide eas-
ily into a receptacle, turn the connector and try
again. If you do not connect the connectors
properly, the console may become damaged
when you use the exercise bike.
Then, insert the excess wire into the Handlebar (4).
11. Tip: Avoid pinching the wires. Attach the
Console (7) to the Handlebar (4) with two
M4 x 16mm Screws (2) in the lower holes in the
Handlebar.
Avoid pinching
the wires
12. Slide the Console Cover (3) upward to the
Handlebar (4). Attach the Console Cover to
the Handlebar and to the Console (7) with two
M4 x 16mm Screws (2).
Next, insert the Handlebar Knob (1) into the
Console Cover (3) and into the Handlebar (4),
rotate the Handlebar to the desired angle, and
then tighten the Handlebar Knob.
23