REINSTALLING THE CABLE
If the cable tends to slip off the pulleys, the cable may have become twisted. Remove the cable and re-
install it.
1. Create slack in the cable by removing the weight pin and pulling
one of the handles out six to eight inches. Insert the weight pin into
the third weight plate and the tube on the bottom of the top weight.
2. Push the black rubber cover off the aluminum coupler and slide the
cover up the cable to contact the swivel arm.
3. Loosen the four M5 x 8mm screws in the coupler and pull the cable
free.
4. Remove the cable from the weight system.
5. Reinstall the cable. (See the CABLE DIAGRAM on page 9 for
proper cable routing.)
6. Reinsert the cable and the sheath into the coupler so that all of the
bare cable is in the hole.
7. Retighten the four screws into the threaded holes. Tighten the screws equally until they contact the cable.
Then, tighten each screw alternately 1/4 turn, until all are set to 85 inch-pounds (9.6 Newton-meters).
8. Slide the rubber coupler cover over the coupler, remove the weight pin, and lower the handle.
Note: If the cable needs to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this
manual.
8
34
63
63
33
77
15
TIGHTENING THE CABLE
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the Cable (33)
when the arms are in
the straight up position
before resistance is felt, the
Cable should be tightened. Note: There will be slack
in the Cable when the arms are in any other position.
Slack can be removed from the Cable (33) by moving
either or both of the indicated 115mm Pulleys (34) in
the brackets on the Top Weight (15). First, remove
the Shroud (not shown). Then, loosen an M10 x
60mm Bolt (77) and an M10 Nylon Locknut (63), and
move the Pulley down. Finally,
make sure the Cable
Traps (78) are oriented as shown in the CABLE
DIAGRAM on page 9
, and retighten the Bolt and the
Nylon Locknut. Then, replace the Shroud.
34
78
Bracket
10
9
37
CHANGING ACCESSORIES
A Handle (9) or the Ankle Strap (not shown) can be
attached to a Cable Eye (37) with a Cable Clip (10).
Attach the other Handle to the other Cable Eye in the
same manner.
Coupler
Cover
Cable
Screws
Screws