Nordcap 467 Series, Instruction Manual, Page: 10 / 38

Instructions Manual
N.º
467_SERIE_A_BEDI
ENUNGSANWEISU
NG_2009-03
467_SERIE_A_BEDIENUNGSANWEISUNG_2009-03 10/39
TEC
1 Reception
On receiving the equipment, check carefully that the packaging is intact and has not been damaged in transit.
After unpacking, check that you have all the components and if the characteristics correspond to those on the order
form.
Installation, maintenance and other work should be carried out by specialised and authorised technicians. The
manufacturer accepts no responsibility and will not cover the guarantee if these conditions are not respected.
As a result of our constant effort to make technological improvements, the specifications indicated here are subject to change
without warning.
2 Identification Plate
Our models have a plate on the inside left side, on which the main data can be found. The MODEL and SERIES are absolutely
essential when consulting the manufacturer.
The European directive on Waste from Electrical and Electronic Equipment (WEEE) specifies that, at the end of its life
cycle, the equipment and all of its components, subassemblies and consumable materials should be sent separately
for treatment for it to be destroyed, recycled or reused.
Do not put equipment with this symbol together with unseparated urban waste.
3 Recommendations for Installation
3.1 General Notes
Although the production and operation (as prove the enclosed test report) of each appliance is rigorously controlled during
manufacture, this does not exclude the possibility of damage caused in transit. The general condition of the appliance should
therefore be checked on arrival.
3.2 Placing

Remove the packaging or pallet carefully so that the equipment’s surfaces are not damaged. Remove the PVC inox
protection.

The appliance should be installed away from heat sources (ex: heating appliances) and direct sunlight.

The vents with openings should never be covered or blocked - must be guaranteed free space to this areas, assuring
a good air circulation.
3.3 Installation
The following standards should always be bared in mind during installation:

Regulations concerning the buildings, and anti-fire standards.

Rules concerning accident prevention.

European standards into effect.

The appliance is supplied with a plug complying test standards, and with a regulation power cord long, enough to allow
connection to the electric socket.
Legend
a) Voltage (V) b) Frequency (Hz)
c) Current (A) d) Power (W)
e) Refrigeration gas
(ASHRAE)
f) Gas capacity (g)